Thomas N. Theis, Paul M. Solomon
Proceedings of the IEEE
This paper concerns the design and characteristics of the high-performance bipolar switching devices and circuits for digital applications at lithographic dimensions of about 1 μm. The impurity profile of the transistors is optimized for speed while maintaining sufficient current gain and punchthrough voltage. The circuits were fabricated on epitaxial wafers of a 0.5 μm flat zone in an advanced bipolar technology featuring self-aligned polysilicon base and emitter contacts, deep-groove device isolation, and electron beam lithography. The experimental results show that n-p-n transistors exhibit a current gain greater than 40 at current densities as high as 1.3 mA/μm2. As a result of reduced line width and polysilicon contacts, the current gain of lateral epibase p-n-p transistors is greater than 20 at low-current levels and remains greater than 1 at a current density as high as 0.12 mA/μm emitter edge. ECL (FI = FO = 1) circuits show a gate delay as low as 114 pS at a power dissipation of 4.9 mW. High-density I2L/MTL circuits (average FI= 2, FO = 2.5, Cw = 90 fF) show delay of 0.91 ns at 0.17 mW. These results demonstrate that the present bipolar technology provides not only high-speed circuits, but also circuits for VLSI applications with density comparable to MOSFET. Copyright © 1982 by the Institute of Electrical and Electronics Engineers, Inc.
Thomas N. Theis, Paul M. Solomon
Proceedings of the IEEE
J. Cai, Tak H. Ning, et al.
S3S 2013
A. Palevski, Paul M. Solomon, et al.
IEEE Electron Device Letters
Pong-Fei Lu, James H. Comfort, et al.
IEEE Electron Device Letters